Peugeot 205 Rally Work / T16 Style Decal Fitting Guide 16 Works Rally Decals fitting guide

Step 1.

Ensure the car surface is dry and clean. Apply the red strip first, in the desired location

Step 2.

Apply the dark blue strip just below the red strip.

Step 3.

Apply the yellow strip just below the dark blue strip. Over-spray the applied decals and surface of the car with water.

Step 4.

Carefully apply the light blue sheet. You'll notice that it is slightly over-sized (this is to cater for any discrepancies as a result of the above steps) so will require trimming.

Step 5.

Using the contour of the yellow sticker as guide, follow the line of the yellow sticker and trim off the excess light blue vinyl.

Step 6.

With a large, flexible straight edeg as a guide, carefully cut the entire decal at the desired angle with a sharp knife/scalpel. Only a very small amount of pressure is required and take care not to cut into the paintwork beneath.

Step 7.

Cut along the door shut line with a sharp knife and tuck the excess decal around the edge of the panel.

Repeat the above steps for the rear decals